Yamaha YZFR6X(C) 2008 Service Manual page 187

3
4
5
7
8
2
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the rod puller attachment.
b. Install the under spring seat.
c. Install the fork spring.
NOTE:
Install the spring with the smaller pitch "a" fac-
ing up "A".
d. Install the upper spring seat.
e. Install the spacer.
f. Install the nut.
g. Reinstall the rod puller attachment.
h. Press down on the spacer with the fork
spring compressor "8".
i. Pull up the rod puller and install the rod
holder "9" between the nut "4" and the
spacer "3".
1
6
NOTE:
Use the side of the rod holder that is marked
"B".
j. Remove the rod puller and rod puller
k. Install the nut "4" all the way onto the
l. Install the damper adjusting rod.
m. Install the washer and cap bolt, and then
n. Hold the nut and tighten the spring preload
4-52
FRONT FORK
Rod puller
90890-01437
Universal damping rod bleeding
tool set
YM-A8703
Rod puller attachment (M10)
90890-01436
Universal damping rod bleeding
tool set
YM-A8703
Fork spring compressor
90890-01441
YM-01441
Rod holder
90890-01434
Damper rod holder double
ended
YM-01434
3
8
attachment.
damper rod assembly.
finger tighten the cap bolt.
adjusting bolt "10" into the cap bolt to spec-
ification.
4
9