Yamaha YZFR6X(C) 2008 Service Manual page 49

Item
Crankcase stud bolt
Pressure plate bolt
Clutch boss nut
Clutch boss plate stud bolt
Drive sprocket nut
Main axle screw
Shift drum retainer bolt
Shift shaft spring stopper
Shift arm bolt
Pickup rotor bolt
Starter motor bolt
Neutral switch
Oil level switch bolt
Speed sensor bolt
Cylinder identification sensor bolt
Negative battery terminal/engine
ground terminal bolt
O sensor
2
NOTE:
Connecting rod nut
Tighten the connecting rod nuts to 15 Nm (1.5 m·kg, 11 ft·lb), and then tighten them further to reach
the specified angle 175°–185°.
NOTE:
Crankcase bolt
1. First, tighten the bolts to approximately 20 Nm (2.0 m·kg, 14 ft·lb) with a torque wrench.
2. Loosen all bolts one by one following the tightening order and then retighten the bolts 12 Nm
(1.2 m·kg, 8.8 ft·lb) with a torque wrench.
3. Tighten at 45°–55° angle according to the tightening order.
4. Tighten at 70°–80° angle according to the tightening order.
NOTE:
Crankcase stud bolt
Install the crankcase stud bolts (M10) so that their installed length is 68.2 mm (2.69 in).
Threa
Q'ty
d size
M10 10
M6 6 8 Nm (0.8 m·kg, 5.9 ft·lb)
M20 1 115 Nm (11.5 m·kg, 85 ft·lb)
M8 6 25 Nm (2.5 m·kg, 18 ft·lb)
M20 1 85 Nm (8.5 m·kg, 63 ft·lb)
M6 3 12 Nm (1.2 m·kg, 8.9 ft·lb)
M6 2 10 Nm (1.0 m·kg, 7.4 ft·lb)
M8 1 22 Nm (2.2 m·kg, 16 ft·lb)
M6 1 10 Nm (1.0 m·kg, 7.4 ft·lb)
M8 1 35 Nm (3.5 m·kg, 26 ft·lb)
M6 2 10 Nm (1.0 m·kg, 7.4 ft·lb)
M10 1 20 Nm (2.0 m·kg, 15 ft·lb)
M6 2 10 Nm (1.0 m·kg, 7.4 ft·lb)
M6 1 10 Nm (1.0 m·kg, 7.4 ft·lb)
M6 1 8 Nm (0.8 m·kg, 5.9 ft·lb)
M6 1 10 Nm (1.0 m·kg, 7.4 ft·lb)
M18 1 45 Nm (4.5 m·kg, 33 ft·lb)
2-18
TIGHTENING TORQUES
Tightening torque
See NOTE
Remarks
Stake
E
LT
Stake
LT
Stake
LT
LT
LT
LT
LT