Maintenance Mode; How To Enter The Maintenance Mode; How To Enter The End User-Accessible Maintenance Mode - Brother DCP-9055CDN Service Manual

1.

MAINTENANCE MODE

The maintenance mode is exclusively designed for the checking, setting and adjustments of
the machine by using the buttons on the control panel. The EEPROM can be customized
according to the destination of the machine. Moreover, the operational check of the LCD,
operation panel board, and sensors, print test, display of the log information and error codes,
and change of the worker switches (WSW) can be performed.
1.1

How to Enter the Maintenance Mode

< Operating procedure>
(1) Press the Menu button and then the Start/Black button while the machine is in the ready
state. Next, press the
Memo:
Operation using Menu, *, 2, 8, 6 and 4 buttons is also available.
(2) The machine beeps for one second and displays "
indicating that it is placed in the initial state of the maintenance mode, a mode in which the
machine is ready to accept entry from the buttons.
(3) To select any of the maintenance mode functions shown in the
maintenance mode that you want to use using the buttons.
Memo:
- To exit from the maintenance mode and switch to ready state, press the 9 button twice in
the initial state of the maintenance mode.
- When the Stop/Exit button is pressed, the machine beeps for one second and returns to
the initial state of the maintenance mode.
- When an incorrect maintenance mode is entered, the machine beeps for one second and
returns to the initial state of the maintenance mode.
1.2 How to Enter the End User-accessible Maintenance
Mode
Basically, the maintenance-mode functions listed in the
service personnel only. However, you can allow end users to access some of these under the
guidance of service personnel by phone, for example.
The end user-accessible functions are shaded in the table given on the
09, 10, 11, 12, 25, 43, 45, 52, 53, 54, 66, 68, 71, 72, 80, 82, 87, 88
Function code 10 accesses the firmware switches, each of which has eight selectors.
The service personnel should instruct end users to follow the procedure given below.
< Operating procedure>
(1) Press the Menu, Start/Black, Menu and
the ready state. "MAINTENANCE 06" appears on the LCD.
(2) Press the
press the OK button.
To switch the machine back to the ready state, press the Stop/Exit button. When each of the
user-accessible functions is completed, the machine automatically returns to the ready state.
button four times to enter the maintenance mode.
or button to display the desired maintenance code on the LCD. Then
next page
buttons in this order when the machine is in
5-1
" on the LCD,
next page, enter the
should be accessed by
next page.(codes
and 91)
Confidential
06,