ABB SROUT Technical Reference Manual page 17

1MRS 750109-MUM
ABB Automation
Router Option Card for Lon® Star Coupler
RER 111
6LQJOHHQGHG
comm_type:
comm_pin_dir:'LUHFWPRGH ± VLQJOHHQGHG
channel type: FXVWRP
comm_clock: 

input_clock:
 3UHVV WKH 5RXWHU 2WKHU 6LGH EXWWRQ
Remember, in this case the parameters mentioned above must be same on the
both router sides. So check the parameters in this window, too.
 ,I \RX PDGH FKDQJHV LQ WKH µ1HDU 6LGH¶ RU µ)DU 6LGH¶ ZLQGRZ SUHVV WKH
:ULWH EXWWRQ WR ZULWH WKH SDUDPHWHU YDOXHV WR WKH URXWHU
 3UHVV WKH &ORVH EXWWRQ WR FORVH WKH 1HXURQ 6WUXFWXUHV 1HDU 6LGH ZLQGRZ
Now you have made the settings for the proper router configuration.
Next you have to download these changes to make them take effect.
+ 6HOHFW &RQILJXUDWLRQ Å 'RZQORDG WR 1HWZRUN« IURP WKH SXOOGRZQ PHQX
 $FWLYDWH WKH URXWHU  LQ WKH 'RZQORDG &RQILJXUDWLRQ ZLQGRZ DQG
SUHVV WKH 6WDUW EXWWRQ
When the download is completed, the router starts to operate as intended.
You can verify that the routing table is correct by making a query through the
router. Send, for example, a 4XHU\ 6WDWXV message to a node in subnet 2.
Because the management node is connected to subnet 1, the Query Status
message goes through the router. If you get an answer, the routing table is
correct.
(behind the 6HOHFW &KDQQHO 7\SH button)
(behind the %LW 5DWH button)
(behind the %LW 5DWH button)
SROUT
17