O7/O9 To Urc Cable; Figure 3-6. Wire Installation With Black Stick; Figure 3-7. O7/O9 To Urc Cable Installation - Motorola ASTRO APX O2 User Manual

Universal Relay Controller Installation O7/O9 Universal Relay Controller Cable Assembly
Black Stick
5. The lightbar gasket should be replaced at each reassembly of the wire.
NOTE: Use of other cable gages except as recommended in this manual may result in water
intrusion. Any reassembly of wire needs a new lightbar gasket replaced. If the current loading
for one wire is higher than 12 A, the wires should be splitted before being assembled to the
URC system. Wires kit (PMKN4109_) is provided to ease installation of the URC. Incorrect
use of the wires kit, e.g. improper connection at external loose end wires, may impact the
robustness of the URC.
Remove the wires and gasket residual inside the URC after the wire installation, before
closing the top housing of the URC.
3.2.4

O7/O9 to URC Cable

The O7/O9 to URC cable (Motorola part number 3064153H02) can be assembled either before or
after reassembling the top housing. Assemble the RJ45 port of the cable into the RJ45 connector on
the URC and turn the locking collar instead of cable, 90 degrees to the right to ensure it is locked
properly. After that, test whether the cable is locked properly or not by trying to pull out the cable.
6878215A01

Figure 3-6. Wire Installation with Black Stick

Figure 3-7. O7/O9 to URC Cable Installation

3-5