Starting With The Vc6000 Series - Motorola VC6000 Series Product Reference Manual

Starting with the VC6000 Series

The VC6000 Series is automatically powered on when connected to the vehicle. The VC6000 Series turns to
Standby mode when the vehicle is turned off. In Standby mode, the screen automatically turns off after some time.
Standby Mode
Standby mode is a power saving mode enabled only when the vehicle
ignition key is switched to the OFF position.
In Standby mode, the screen display and backlight illumination
automatically turn off after a period of two minutes when VC6000 Series
is not active.
Resume from Standby Mode
To resume from Standby mode, press any key, touch the screen or momentarily press the Power Button
The VC6000 Series can be programmed to automatically resume from Standby mode when: turning On the ignition
key, connecting or removing a USB device, pressing a keyboard key, receiving an alarm, pressing the touch
screen, communicating over Bluetooth, communicating over WWAN, Telemetry signal (1939 protocol only),
Ethernet signal (magicPacket), GPIO signal.
To program the operation of Standby mode, refer to the VC6000 Series Software Enterprise Mobility Developer Kit
for C (EMDK).
Controlling Screen Brightness
There are five levels of screen brightness.
To adjust the brightness of the screen, press the Brightness down button to decrease the brightness or the
Brightness up button to increase the brightness.
Controlling Keypad Illumination
There are five levels of keypad illumination. To adjust the keypad illumination:
Press the Ctrl key to lock in down position.
1.
Press the Brightness up/down key to increase/decrease the keypad illumination.
2.
Press the Ctrl key to unlock in up position.
3.
Getting Started
Power Button
Power Button
Figure 1-5
1 - 9
.