Remove And Attach The Bobbin Case; Wind The Bobbin; Attach Bobbin Into Bobbin Case - Zanussi ZAN2250 User Manual

Anl.790.GB/SE/DK/FI/CZ/HU
REMOVE REMOVE AND LOAD THE BOBBIN CASE AND LOAD THE BOBBIN CASE
Live the Cover
(1) Cover
Turn forward the balance wheel to raise the
needle. Hold on to the bobbin exit and pull
out the bobbin case.
(3) Bobbin case handle
WINDING
WINDING
(1) Pull out the balance wheel to the right so as to break contact with machine (2) Draw thread from the spool through the bobbin
winder tension disc. (3) Pull thread through the hole in the bobbin and insert the bobbin into the bobbin shaft.
(4) Turn the bobbin to the right. (5) Hold the end of the thread and keep stepping down the foot controller. Stop the after several
turns.Cut the excess thread close to the bobbin. (6) Stop down again the foot controller. Wind thread until the bobbin is full and
stop the machine. Push the shaft to the left and cut the thread. (7) Push the balance wheel to the left to close contact
(to the original position).
Instruction: The bobbin shaft is to be pushed to the left when the winding finished.
PUT THREAD INT
PUT THREAD INT
Load bobbin in bobbin case. Make sure that the thread is pulled out in the direction indicated by the arrowhead (clockwise).
(2) Pull thread into the slit of bobbin case.
(3) And then, pull thread through bobbin tension regulator spring to the outlet hole.
Instruction: pull thread out about 10 cm.
13.09.2006 13:32 Uhr
(2) Bobbin exit
Press the bobbin case handle to the inner-
most to ensure joining when loading it into
the bobbin case.
O THE BOBBIN CASE
O THE BOBBIN CASE
Seite 8
6
(3) Bobbin case handle
(3) Spulenkapselfinger