JVC HM-HDS1EU Instructions Manual page 92

92
EN
TIMER RECORDING
SYMPTOM
1. Timer recording won't work.
2. Timer programming is not
possible.
3. " " and " " on the front display
# [
panel won't stop blinking.
4. " " blinks for 10 seconds and the
#
Timer mode is disengaged.
5. The S V system does not
HOW IEW
timer-record properly.
POSSIBLE CAUSE
The clock and/or the timer have
been set incorrectly.
The timer is not engaged.
Timer recording is in progress.
The timer is engaged but there's no
cassette loaded.
The loaded cassette has had its
record safety tab removed.
The end of the tape was reached
during timer recording.
has been pressed when there are
#
no programs in memory.
The recorder's channel positions
have been set incorrectly.
TROUBLESHOOTING (cont.)
CORRECTIVE ACTION
Re-perform the clock and/or timer
settings.
Press and confirm that "
#
displayed on the front display panel.
Timer programming can't be
performed while a timer recording is
in progress. Wait until it finishes.
Load a cassette with the record safety
tab intact, or cover the hole using
adhesive tape.
Remove the cassette and cover the
hole with adhesive tape, or insert a
cassette with the record safety tab
intact.
The programme may not have been
recorded in its entirety. Next time
make sure you have enough time on
the tape to record the entire
programme.
Check the programmed data and re-
program as necessary, then press
again.
Refer to "Guide Program Number
Set" ( pg. 79) and re-perform the
procedure.
" is
#
#