Details Of The Service Mode - Pioneer CDJ-2000 Service Manual

5

6.3 DETAILS OF THE SERVICE MODE

[1] Confirmation of the button input and an indication function
When it spends a power supply while pushing a TEMPO button and a MEMORY button simultaneously, It is displayed in the
LCD display part, "CDJ-2000 SERVICE MODE", and enters into this mode. (Please continue pushing until "Pioneer LOGO"
screen disappears.)
When it enters this mode, the TAG-TRACK button is pushed, and the screen is sent as follows, the following status displays
are done.
In this mode, the input of each button, JOG, volume, etc. is normal, and it can check that a display can also be performed
normally.
In addition, indication turns on while you push a button.
Caution: In this status display, if a TOUCH/BRAKE knob is turned to the limit of the right, it will shift to "the load measurement
mode of JOG."(Refer to the following clause. )
5
6
BUTTON : The pushed button name is displayed.
JOG : The point moves according to the direction that JOG turned.
ENCODER : The point moves according to the direction that ENCODER
switch turned.
NEEDLE : The point moves according to the direction to which touched the
needle pad and it was made to move.
SLIDER VOLUME
JOG TOUCH VOLUME
JOG RELEASE VOLUME : If a RELEASE/START knob is turned to the right,
CDJ-2000
6
7
: If a TEMPO slider knob is moved to the - side, a bar
display will increase.
: If a TOUCH/BRAKE knob is turned to the right,
a bar display will increase.
the Bar display will increase.
7
8
A
B
C
D
E
F
45
8