Pioneer CDJ-2000 Service Manual page 53

5
It is indicated in the indication part as follows.
[SEARCH L0 IN] Layer 0 inside
[SEARCH L0 MID] Layer 0 middle
[SEARCH L0 OUT] Layer 0 outside
Note: A search address is different in inside/middle/outside at total capacity of a Disc in a relative address.
Outside searches about 20000 sector I than a Disc most circumference address.
Error Rate Count
Measure an error rate of 10000 blocks in the case of DVD in the case of a CD from a present position doing a play/pause
for about 20 seconds and display a measurement result in FL.
Usually, a track to measure is made to search and this button is inputted from a pause state.
For example, it is displayed as "3.56E-4 O.K." etc.
If an error rate is less than 3.00E-3, it will be displayed as O.K. If an error rate is larger than 3.00E-3, it will be displayed
as NG. Measurement with the managed disk at the time of factory shipments is a premise.
The product does not judge whether they are inferior goods at the time of service.
Eject
A disk is ejected. It is indicated with [EJECT] in the indication part.
Mode Change (It shifts to the Test opalation mode.)
If the MASTER TEMPO button is pushed into player operation mode, MASTER TEMPO LED will light up, and it will shift to
the below-mentioned "test operation mode." It is indicated with [TEST MODE] in the indication part.
Test operation mode command
Serbo operation is finely controllable gradually.
Keep in mind a test operation mode command that it may give a damage to a player as mistaking the usage.
Please operate this mode after making a dis c a set completion state.
Note: Operate it after you take a state of loading in.
Servo All Off
When servo is ON, all servo will be turned off if the TIME button is pushed.
It is indicated with [ALL OFF] in the indication part.
CD Select
When you start a CD, push a MEMORY button and choose a CD.
It is indicated with [CD SELECT] in the indication part.
DVD Select
When you start a DVD, push a CALL button and choose a DVD.
It is indicated with [DVD SELECT] in the indication part.
Focus Jump Up
In DVD choice, a focus jumps in L1.
It is indicated with [FOCUS JUMP UP] in the indication part.
Focus Jump Down
In DVD choice, a focus jumps in L0.
It is indicated with [FOCUS JUMP DOWN] in the indication part.
Slider Move Fwd
You send about 1.8 mm sliders to a circumference direction whenever you push a SEARCH FWD button.
It is indicated with [SLIDER FWD] in the indication part.
Slider Move Rev
You send about 1.8 mm sliders to an internal circumference direction whenever you push a SEARCH REV button.
It is indicated with [SLIDER REV] in the indication part.
5
6
[SEARCH L1 IN] Layer 1 inside
[SEARCH L1 MID] Layer 1 middle
[SEARCH L1 OUT] Layer 1 outside
CDJ-2000
6
7
7
8
A
B
C
D
E
F
53
8