Asi Output Menu - Motorola DSR-6100 Operator's Manual

ASI Output Menu

Press the  buttons until the ASI Output menu appears. Use this menu to
configure the digital ASI output. It is used to define the format of the ASI output
and to enable PID aliasing.
ASI OUTPUT Enable Format Pid Alias
E On Packet On
Note: The DSR-6100 provides two ASI outputs:
ASI#1: The DSR-6100 has the ability to output an MPEG-4 transport multiplex
stream at a data rate of either 54 Mbps or 81 Mbps, depending on whether PID
aliasing is enabled or not. When PID aliasing is enabled, the DSR-6100 outputs an
MPEG-4 transport stream that contains only one MPEG program and at a data
rate of 54 Mbps; that program is identified as MPEG Program #1 and the PIDs for
the constituent components are remapped to a consistent set, as described in Tables
3-1 and 3-2 on page 36. This MPEG program corresponds to the program content
that is available at the analog video and audio outputs (the monitored program).
Otherwise, when PID aliasing is disabled, the DSR-6100 outputs an MPEG
transport stream at a data rate of 81 Mbps, which contains all of the MPEG
programs that the DSR-6100 receives from the uplink.
ASI#2: The DSR-6100 also has the ability to convert the incoming MPEG-4
program to both an MPEG-2 HD (High Definition) Program and a MEPG-2 SD
(Standard Definition) Program. Both the HD and the SD programs are carried in
the same transport stream and at a data rate of 54 Mbps. The SD program is
identified as MPEG program #1 and the HD Program is identified as MPEG
Program #2. The PIDs are identified in Tables 3-1 and 3-2 on page 36.
35
DSR-6100