Enable Field; Format Field; Pid Alias Field; Reset Menu - Motorola DSR-6100 Operator's Manual

Enable Field

Note: The ASI output can be disabled by control information from the Uplink
Programmer (Broadcast Network Controller [BNC]).
When ASI output is disabled by the BNC, this field is not editable and displays Lock
Off. Otherwise, if the BNC enables the ASI output, this field is editable with the
default value (On). Press the  buttons to display the options (On and Off).

Format Field

When PID Alias is set to On, use this field to specify the transport stream packet
structure either as a burst of contiguous bytes (Packet), or as individual bytes (Byte).

Pid Alias Field

When this field is set On, the DSR-6100 remaps all PIDs to a constantly-set of values
and incorporates the remapped value in the output transport stream. When the Uplink
Programmer enforces PID aliasing, the PID Alias field displays Lock On and
becomes uneditable.

Reset Menu

Press the  buttons until the Reset menu appears. Use this menu to execute
factory defaults and perform power cycle resets.

Reset Type Field

Press the 4 button until the cursor is at the Reset Type label, and press the ENTER
button to move into the field. Press the  buttons to display the options: No,
Factory Defaults, or Power Cycle.

Factory Defaults Option

Use the Factory Defaults option to reset the system to the programming values
originally set by the factory firmware.
CAUTION: Selecting this reset option deletes all defined setups and downloaded
information. This operation interrupts service output, so use it carefully.
Press the ENTER button. The following caution message appears and indicates that
all programming will be lost if the action proceeds.
DSR-6100
Default: On
Default: Packet
Default: On
RESET Reset Type
E No
Default: No
CAUTION: IRD memory will be reset
Press E to continue or to stop
37