Mpeg Select Menu; Program Field - Motorola DSR-6100 Operator's Manual

MPEG SELECT Menu

Use this menu to select which service is displayed at the video and audio outputs by
specifying the MPEG program number. Press the  buttons until the MPEG
SELECT menu appears. The MPEG program number can be used instead of a
Virtual Channel, but only if the DSR-6100 is already tuned to the appropriate
L-band or ASI input signal.

Program Field

Press the 4 button until the cursor is at the Program label, and press the ENTER
button to move into the field. While ensuring that the cursor remains on the up/
down symbol ( ), press the  buttons to scroll throughout the available MPEG
programs. (If the current L-band or ASI input signal contains four MPEG
programs, then only four MPEG programs appear in this field.) Press the ENTER
button to confirm the selection and exit the field.
This field also provides a second method for selecting the MPEG program. Use the
4 buttons to select the digit to change and then, while the cursor is on that digit,
press the  buttons to display the required value. Repeat this process for each
applicable digit. Press the ENTER button to confirm the selection and exit the field.
The DSR-6100 displays caution messages for the following conditions:
•
•
DSR-6100
 MPEG SELECT
E
 
A caution message is displayed when changing from a Virtual Channel to a
MPEG program number. Press any arrow button ( 4 ) to back out of the
field and leave it unchanged. Otherwise, press the ENTER button to proceed.
CAUTION: Changing to MPEG selection mode
Press E to continue or
A caution message displays when an MPEG program number is selected which
does not exist.
CAUTION: Program ddddd does not exist
Press E to continue or
Press any arrow button ( 4 ) to back out of the field and leave it
unchanged. Otherwise, press the ENTER button to proceed.
 Program
00000
Default: 00000
to stop
to stop
43