E-Mail Settings - JVC LST0728-001C Instructions Manual

E-mail Settings

G
[E-mal setup] Screen
A
Enable E-
mail(Monitor)
B
A Recipient(S)
B
C
Sender
Settings
D
Subject text
C
E
Message text For specifying the message text.
F
Time
btw.mail(min
utes)
G
Include
D
Image
Memo :
E
● You can send a test e-mail by clicking the [Test] button. If the e-
mail address of the sender is not registered with the mail server
of the recipient, the [The mail address of the sender is not valid.
F
...] message may appear. When this occurs, double-check the
sender's e-mail address and outgoing mail server, and re-enter
the e-mail address.
● E-mail messages are sent in the following cases.
● When an input event occurs
● When the event button is clicked
● When a generic event occurs
● When motion is detected
● When camera failure occurs
● When an archiving error occurs
● In order to send an e-mail via Motion Detection, you need to
specify the timing for sending out e-mails in [Scheduler Setting]
(A Page 53).
● After you have completed the e-mail setting, perform a test to
verify that it can be sent successfully.
Item
Select this check box to enable sending of
e-mail alerts.
For specifying the e-mail addresses to
send alerts to. If you are specifying more
than one e-mail address, separate the e-
mail addresses using semicolons.
For specifying the sender's e-mail address,
outgoing (SMTP) mail server name and
login settings.
For specifying the mail title.
For specifying the time interval (minutes)
for sending each e-mail alert.
Select this check box to include images in
the message.
(A Page 96 [Specifying an Input Event])
(A Page 99 [Configuring Event Buttons])
(A Page 100 [Specifying Generic Events])
(A Page 105 [Specifying Motion Detection])
(A Page 108 [Archiving])
Description
107