JVC LST0728-001C Instructions Manual page 97

E
Camera Type For specifying whether the camera corresponding to the selected number is [Fixed] or [Moveable].
Fixed
Moveable
F
This option is enabled only if AMoveableB is selected in the [Camera Type] item E.
Device Port
For specifying which control port on the network encoder (IP video server) to use for controlling the PTZ features.
G
This option is enabled only if AMoveableB is selected in the [Camera Type] item E.
Port Addr.
Use this option to specify the port address of the camera. The port address is usually set to A0B or A1B.
If the PTZ cameras are serially connected, they are identified by their the port addresses. Refer to the camera's
[INSTRUCRTIONS] for the recommended settings.
[CAMERA CONTROL] Terminal at the Rear
of VR-N900U (VR-N900U)
The analog camera acts as a network encoder (IP video server) in
the VR-N900U system, and the device name assigned to it is
[N900]. The [CAMERA CONTROL] terminal at the rear is assigned
as ACOM1B on the Camera Settings screen.
(A Page 88)
: Fixed Camera
: PTZ Camera
89