Toshiba e-studio2050c Troubleshooting Manual page 13

Message
READY(*** TONER NOT
RECOGNIZED)
Check the toner cartridge
READY (SADDLE STITCH
TRAY FULL)
READY (CHECK SADDLE
STITCH STAPLER)
READY (CHECK SADDLE
STITCH STAPLER)
READY (CHECK STAPLER)
READY (CHECK STAPLER)
READY (HOLE PUNCH
DUST BIN IS FULL)
READY (FINISHER FULL)
READY (INNER TRAY FULL)
Cannot copy
Check DEPARTMENT
COUNTER
Add paper
Call for service
Examine stapler in the Saddle
Stitch unit
Problem Description
The toner cartridge indicated
by *** is not installed at all or
improperly so.
The terminal of the toner
cartridge is stained.
The recommended toner
cartridge is not being used.
The saddle stitch tray of the
finisher is full of paper.
Staple jam has occurred in the
stapler of the saddle stitch
unit.
No staples are left in the
stapler of the saddle stitch
unit.
Staple jam has occurred in the
stapler of the finisher.
No staples are left in the
stapler of the finisher.
Hole punch dust bin is full of
paper punchings.
The receiving tray of the
finisher is full of paper.
The exit tray of the equipment
is full of paper.
The number of originals to be
scanned has exceeded the
limit specified with the
department code during
scanning.
No paper is left in a drawer or
on the bypass tray.
The equipment requires
adjusting by a service
technician.
Staple jam has occurred in the
stapler of the saddle stitch
unit.
1 TROUBLESHOOTING FOR THE HARDWARE
Corrective Action
Install the toner cartridge correctly.
P.45 "Replacing a Toner Cartridge"
Wipe the terminal with a soft cloth.
Use the recommended toner cartridge.
P.45 "Replacing a Toner Cartridge"
Remove the paper from the saddle stitch
tray of the finisher.
Remove the jammed staples.
P.43 "Staple jam in the Saddle Stitch
unit"
Refill the staples.
P.57 "Refilling Saddle Stitch unit
staples"
Remove the jammed staples.
P.39 "Clearing a Staple Jam"
Refill the staples.
P.54 "Refilling With Staples"
Remove the paper punchings.
P.62 "Cleaning the Hole Punch Dust
Bin"
Remove the paper from the receiving tray
of the finisher.
Remove the paper from the exit tray of the
equipment.
Ask your administrator for details of setting
the limit for the number of copies.
Set paper in the drawer or on the bypass
tray. The touch panel indicates which
drawer (or the bypass tray) has no paper.
To set paper, refer to the Copying Guide.
Contact your service representative with
the error code displayed on the right side of
the touch panel.
Never attempt to repair, disassemble or
modify the equipment by yourself.
You could cause a fire or get an electric
shock.
Always contact your service representative
for maintenance or repair of the internal
parts of the equipment.
Remove the jammed staples.
P.43 "Staple jam in the Saddle Stitch
unit"
Messages Displayed on the Touch Panel 11