Paper Misfeed In The Bridge Kit; Paper Misfeed In The Inner Finisher And The Hole Punch Unit - Toshiba e-studio2050c Troubleshooting Manual

1 TROUBLESHOOTING FOR THE HARDWARE

Paper misfeed in the Bridge Kit

1 Open the cover holding the handle of the Bridge Kit.
2 Remove the misfed paper inside the Bridge Unit.
If the misfed paper cannot be removed because the right
side is caught by the fuser unit, follow the steps on
"Paper misfeed in the fuser unit".
Close the Bridge Kit cover.
3

Paper misfeed in the Inner Finisher and the Hole Punch Unit

Lift up the control panel and then open the front cover
1
of the finisher.
While holding the green lever, move the finisher to the
2
left until it stops.
28 Clearing a Paper Misfeed
P.25
2
1
2
1