Checking The Engine Idle Speed - Yamaha F200C Service Manual

CHK
ADJ
5. Adjust the position of the shift cable joint
until its hole is aligned with the set pin.
CAUTION:
The shift cable joint must be screwed in a
minimum of 8.0 mm (0.31 in) c.
6. Connect the cable joint, install the clip,
and then tighten the locknut.
7. Check the gearshift for smooth operation
and adjust the shift cable length, if nec-
essary, repeating steps 3–6.

Checking the engine idle speed

1. Remove the ignition coil cover.
2. Start the engine and warm it up for 5 min-
utes.
3. Attach the special service tool to spark
plug wire #1 1, and then check the
engine idle speed. Adjust if out of specifi-
cation.
3-13
Periodic checks and adjustments
S69J3370
Inductive self-powered tachometer:
YU-08036-B
Engine idle speed: 650–750 r/min
4. Turn the engine off, loosen the locknut
2, and then disconnect the link rod 3
from the magnet control lever 4.
5. Loosen the port throttle stop screw 5
until it separates from the throttle body
lever 6.
6. Start the engine, and then turn the star-
board throttle stop screw 7 in direction
a or b until the specified engine idle
speed is obtained.
69J1D11