Bleeding The Power Trim And Tilt Unit; Not Installed - Yamaha F200C Service Manual

BRKT
WARNING
To prevent the power trim and tilt fluid
from spurting out due to internal pres-
sure, the tilt ram should be kept at full
length.
NOTE:
Place the tilt cylinder end screw at the bottom
of the tilt ram and install the tilt piston assem-
bly into the tilt cylinder.
Trim and tilt cylinder wrench:
YB-06175-2B
Trim cylinder end screw:
90 N·m (9.0 kgf·m, 65 ft·lb)
Bleeding the power trim and tilt
unit

Not installed

1. Tighten the manual valve 1 by turning it
clockwise.
2. Place the power trim and tilt unit in an
upright position.
3. Check the fluid level in the reservoir.
NOTE:
The fluid level should be at the brim of the
filler hole.
4. If necessary, add sufficient fluid of the
recommended type to the correct level.
7-41
Bracket unit
Recommended power trim and tilt
fluid:
ATF Dexron II
5. Install the reservoir cap.
6. Connect the PTT motor leads 2 to the
battery terminals.
7
Ram
Up
Down
7. Reverse the PTT motor leads between
the battery terminals to fully extend the
tilt ram and trim rams, and then reverse
them again to fully retract the rams.
PTT motor lead
Sky blue (Sb)
Light green (Lg)
Light green (Lg)
Sky blue (Sb)
Battery
terminal
+
-
+
-
69J1D11