! Please also remember that vibrations from subwoofer systems can shake other loudspeakers out of place, which may present a toppling hazard. ! Do not attempt to use the product with the XY-152 grille detached as doing so could result in damage to the product. Consult a qualified professional for assistance with removing the grille for maintenance purposes.
The XY-152 comes with pre-inserted mounting screws. These screws can be taken out and used to attach either special mounting hardware designed for the product or com- mercially available mounting hardware. Make sure to attach a wire for preventing falling parts and equipment of adequate strength using screw holes not used by mounting hardware.
90 ° × 60 ° rotatable waveguide. These components are matched by an internal passive crossover network for unprecedented sonic quality from a completely passive enclosure. Due to its discreet size and appearance, the XY-152 can be used in a wide variety of applications ranging from fills and delays in nightclub use to medium scale front of house and DJ booth monitoring duty.
Damage to the ear can result from levels above 90 dB under prolonged exposure. Stand mounting The XY-152 can be mounted from a loudspeaker stand using the integral polemount adapter for a standard 35 mm (1.4 in.) loudspeaker stand. When mounting in this way, please consider the following: ! Ensure your stand height is locked off and the tripod legs are positioned so as to be stable.
! With any suspension method, a second anchor point should be used as a safety feature. ! Under no circumstances should the mounting points of one enclosure be used to suspend another enclosure below it. Pioneer is in no way responsible for the failure of incorrectly rigged systems.
For larger down-tilt angles, position the pivot on the last hole and use the point on the rear or underside as a pull-back. Ensure that an M10 eyebolt is secured to the top point on the XY-152 enclosure to use as a secondary safety feature.
! Hole layout (pitch): 127 mm × 70 mm (5 in. × 2.8 in.) ! Be sure to use wall mount brackets that have enough strength to be able to withstand the weight of the XY-152. To rotate the HF waveguide Using a 4 mm Allen key, unscrew the six M6 screws in the top and bottom of the enclosure (3 at each end).
! The INPUT and LINK connectors used are Neutrik SpeakON NL4 connectors. Internal connection diagram ™ ! Refer to the internal connection diagram and make the appropriate connections as shown. XY-152 Rear view 1 INPUT connector 2 LINK connector Neutrik NL4 Connector...
About trademarks and registered trademarks ! Pioneer is a registered trademark of PIONEER CORPORATION. ! SpeakON is a registered trademark of Neutrik. The names of companies and products mentioned herein are the trademarks of their respective owners. Specifications Enclosure Type...
Page 13
PIONEER GULF FZE Lob 11-017, Jebel Ali Free Zone P.O. Box 61226, Jebel Ali Dubai TEL: 971-4-8815756 PIONEER ELECTRONICS DE MEXICO S.A. DE C.V. Blvd.Manuel Avila Camacho 138 10 piso Col.Lomas de Chapultepec, Mexico, D.F. 11000 TEL: 55-9178-4270 PIONEER INTERNATIONAL LATIN AMERICA S.A.