Sanyo VPC-R1E Service Manual page 10

4. Power Supply Control
The 8-bit microprocessor controls the power supply for the overall system.
The following is a description of how the power supply is turned on and off. When the battery is attached, a regulated 3.2 V
voltage is normally input to the 8-bit microprocessor (IC301) by IC302, so that clock counting and key scanning is carried out
even when the power switch is turned off, so that the camera can start up again. When the battery is removed, the 8-bit micro-
processor operates in sleep mode using the backup capacitor. At this time, the 8-bit microprocessor only carries out clock
counting, and waits in standby for the battery to be attached again. When a switch is operated, the 8-bit microprocessor supplies
power to the system as required.
The 8-bit microprocessor first sets the P ON signal at pin (34) to high, and then turns on the DC/DC converter for the digital
system. After this, it sets RESET B signal at pin (33) to high so that the ASIC is set to the active condition.
After this, in case of driving the CCD, it sets the P (A) ON signal at pin (176) of the ASIC to high, and then turns on the DC/DC
converter for the analog system.
If the LCD monitor is on, the LCD ON signal at pin (175) of the ASIC set to high, and the DC/DC converter for the LCD monitor
is turned on. Once it is completed, the ASIC returns to the reset condition, all DC/DC converters are turned off and the power
supply to the whole system is halted.
Power voltage
Power OFF
Power switch ON-
Shutter switch ON
CAMERA
Resolution, flash, self-timer switch ON
Play back
Note) 4 MHz = Main clock operation, 32 kHz = Sub clock operation
Auto power OFF
LCD finder
Table 4-3. Camera Mode
ASIC,
CCD
memory
5 V (A)
3.3 V
+12 V etc.
OFF OFF
OFF
OFF
ON→ → → → → OFF
ON
OFF
OFF
ON
ON
ON
OFF
– 10 –
8 bit LCD
CPU MONITOR
3.2 V
+12 V etc.
(ALWAYS)
32KHz OFF
4 MHz OFF
4 MHz OFF
4 MHz OFF
4 MHz ON
4 MHz ON