Table of Contents
Advertisement
4. Strobe Adjustment
Camera
Adjustment method:
1. Copy all the CCD calibration files to the CF card.
2. Click on Cmdfile.txt to activate the name field in the CF
card, and push the enter key to change the name to
"strobecal" using all lower case letters. Click the save but-
ton to save.
3. Set the CF card which is saved to the camera.
4. Place the camera on the stand in a condition turned to the
bottom of the strobe adjustment box straightly.
5. Slide the lens cover and put DC jack to the camera in order
to turn on the camera. Start the adjustment automatically,
and strobe emits several times.
When the adjustment is completed, the "OK" message will
appear on the LCD monitor. If an error occurs during the
process, the "EC***" message will be displayed, and you
must perform the adjustment again.
6. Pull the DC jack to turn off the camera after completing the
adjustment, and pull the CF card.
5. LCD Panel Adjustment
[CP1 board (Side B)]
CL528
VR502
(Side A)
Note:
This adjustment is not necessary only the case of exchanging
LCD. Perform the 3. CCD adjustment and 4. Strobe adjust-
ment after completing the LCD adjustment.
Adjustment method:
1. Copy all the CCD calibration files to the CF card.
2. Click on Cmdfile.txt to activate the name field in the CF
card, and push the enter key to change the name to "lcdcal"
using all lower case letters. Click the save button to save.
3. Set the CF card which is saved to the camera.
4. Put DC jack to the camera in order to turn on the camera.
Gray
sheet
CL307
CL310
CL415
CL413
CL414
CL400
CL411
5-1. LCD H AFC Adjustment
Adjusting method:
1. Double-click on the DscCalDi.exe in the DscCalDI.128a.
2. Select 0 on the LCD "H AFC".
3. Apply a trigger using CL400, and adjust LCD "H AFC" so
that the time A from the rising signal at CL400 to the fall-
ing signal at CL411 is 5.54 ± 0.1 µsec.
CL411
CL400
CL411
CL400
5-2. LCD RGB Offset Adjustment
Adjusting method:
1. Adjust LCD "RGB Offset" so that the amplitude of the CL415
waveform is 4.0 V ± 0.1 Vp-p.
5-3. LCD Gain Adjustment
Adjusting method:
1. Adjust LCD "Gain" so that the amplitude of the CL415 wave-
form is 6.6 V ± 0.2 Vp-p.
Note:
5-2. LCD RGB Offset adjustment should always be carried
out first.
– 16 –
A
Enlargement
A
4.0 V ±
0.1 Vp-p
CL415 waveform
Advertisement
Table of Contents
