Table of Contents
Advertisement
15.2.2 S48 Force fax 14.4kB
Command
Response
set
S48=<n>
read
S48?
<n>
Mandatory when a 14.4kB fax service is implemented. This command is used to force a
14.4kB fax service on. Value 0 is recommended if the network or phone doesn't support the
14.4kB service. 0=disabled, 1=enabled.
16. RESULT CODES
16.1 V.25TER
16.1.1 Basic syntax result codes
OK, ERROR, BUSY, CONNECT, CONNECT <rate>, NO ANSWER, NO CARRIER: see V.25ter
section 5.7.1 and X, D, A and O commands in this document. Note that OK may be a result of
a successful, remotely initiated in-call modification from data to speech mode, and
CONNECT[ <rate>] a result of a successful, remotely initiated in-call modification from
speech to data mode (when alternating calls are supported by the product). NO CARRIER
can also indicate a remote hang-up of a speech call. No OK shall be returned when a voice
call is originated/answered through the external ME UI.
16.1.2 +DR Data compression report
Format
Description
given when +DR=1; informs about the presence of V.42bis data compression in the established
+DR: <type>
connection
V.25ter section 6.6.2. This intermediate result code is given after a (possible) +ER result
code.
16.1.3 +ILRR DTE-DCE local rate report
Format
+ILRR: <rate>[,<rxRate>]
V.25ter section 6.2.13. <rxRate> parameter is not needed with the Nokia D211. This
intermediate result code is given after a (possible) +DR result code.
<n> values
0..1(default 0)
000..001
Description
given when +ILRR=1; informs about the local port rate after connection
establishment
99/113
Advertisement
Table of Contents
