Table of Contents
Advertisement
L-2 SELECT and L-2 INPUT Setting
The L-2 IN/DECODER connector accepts either a composite
signal (regular video signal) or a Y/C signal (a signal in which the
luminance and chrominance signals are separated). Set "L-2
SELECT" to the appropriate mode depending on the type of
appliance connected to the recorder's L-2 IN/DECODER
connector. Set "L-2 INPUT" to the appropriate mode depending
on the output signals of the connected appliance.
Perform steps 1 and 2 of "L-1 OUTPUT Setting" on page 30.
A
Select the input mode for the L-2 IN/
DECODER connector.
Press
to move the
rt
highlight bar (pointer) to "L-2
SELECT" or "L-2 INPUT".
Then, press OK or
to select
e
the appropriate setting.
* The default setting is bold in
the table below.
L-2 SELECT
8
A/V:
To use this recorder as the recording
deck with the player connected to
the L-2 IN/DECODER connector, or
to use the satellite receiver
connected to the L-2 IN/DECODER
connector.
DECODER:
To use a decoder connected to the
L-2 IN/DECODER connector.
To view a satellite programme with
SAT:
the TV set while the recorder is
turned off. (
L-2 INPUT
8
VIDEO:
If a connected appliance's output is
compatible only with regular video
signals, set to "VIDEO".
S-VIDEO:
If a connected appliance's output is
compatible with Y/C signals, set to
"S-VIDEO". You can obtain
high-quality S-VHS picture. (For
connection, be sure to use a 21-pin
SCART cable that is compatible with
the Y/C signal.)
B
Return to the normal screen.
Press MENU.
pg. 32)
NOTES:
If you have a satellite receiver or a decoder connected to the
L-2 IN/DECODER connector, be sure to set "L-2 SELECT" back
to appropriate mode after editing.
If you are not connecting a satellite receiver or a decoder to
the L-2 IN/DECODER connector, leave "L-2 SELECT" set to "A/
V".
The default setting is "A/V"; if the recorder's memory backup
has expired due to a power cut or because the AC was
removed from the recorder, "A/V" will be automatically
selected when the power is restored to the recorder. If you are
using a satellite receiver or a decoder, be sure to set "L-2
SELECT" back to appropriate mode.
When "L-2 SELECT" is set to "SAT", "SAT" or "SAt" appears on
TV screen or front display panel instead of "L-2" or "L2".
If "L-2 SELECT" is set to "DECODER", it is impossible to set
"L-2 INPUT" to "S-VIDEO".
If "L-1 OUTPUT" is set to "S-VIDEO", it is impossible to set
"L-2 SELECT" to "DECODER".
31
EN
Advertisement
Table of Contents
