Yamaha 2006 FJR1300AS Service Manual page 53

NOTE:
Fit the projections on each handlebar into the
holes in the upper bracket, making sure that the
handlebars are installed in the same position.
a a a a
b b b b
c c c c
a. Front position
b. Standard position
c. Rear position
7. Install:
• Handlebar bolts "1"
(temporarily)
• Handlebar nuts "2"
(temporarily)
2
1
2
8. Tighten:
• Handlebar bolts
• Handlebar nuts
Handlebar bolt
23 Nm (2.3 m·kg, 17 ft·lb)
Handlebar nut
65 Nm (6.5 m·kg, 47 ft·lb)
NOTE:
First tighten the bolts, then tighten the nuts.
9. Install:
• Throttle grip
• Throttle cables
• Throttle cable housing "1"
• Grip end "2"
NOTE:
• Make a loop in the right grip warmer lead "3" as
shown in the illustration, making sure that the
section of the lead from the grip warmer cross-
a a a a
b b b b
c c c c
– 44 –
es to the rear of the other section of the lead,
and route the lead through the throttle cable
housing.
• When installing the throttle cable housing,
align the projection "a" on the housing with the
hole "b" in the right handlebar and be sure not
to pinch the right grip warmer lead.
• There should be 1–3 mm (0.04–0.12 in) of
clearance "c" between the throttle grip and the
grip end.
1
10.Install:
• Front brake master cylinder assembly
• Front brake master cylinder holder "1"
Front brake master cylinder hold-
er bolt
10 Nm (1.0 m·kg, 7.2 ft·lb)
NOTE:
• Install the brake master cylinder holder with the
"UP" mark facing up.
• Align the projection "a" on the front brake mas-
ter cylinder with hole "b" on the right handlebar.
HANDLEBARS
1
3