Panasonic KX-TDA0490 Getting Started page 133

Note
If the upload operation is executed while the card is in the "RUN" status, you will see an
error screen. Click Change RUN/STOP status Screen and place the card in the
"STOP" status (see "3.2.1 Status Control"), and then upload the data again.
Firmware Status shows the current firmware status of page 0 and page 1, and Startup
Page shows the current active page on startup. For details about these parameters, refer to
"3.3.2 Handling of Firmware Page".
3.
Do the following to update the desired page with the uploaded firmware data:
a.
In Select Page, click the page whose current firmware status is not "Main Operation Mode".
b.
Click OK.
You will see a confirmation screen.
c.
Click OK.
3.3 Data Management
Programming Guide 63