Programming The Pbx In The Los Angeles Office - Panasonic KX-TDA0490 Getting Started

4.1 Programming the PBX in the Los Angeles Office

4.1 Programming the PBX in the Los Angeles
Office
For successful operation of a VoIP network using the VoIP Gateway Card as a QSIG network
interface, the PBX at each location in the network must be programmed appropriately. For a detailed
discussion of related features, refer to the Hybrid IP-PBX Feature Guide.
This section details the procedure to programme the PBX in the Los Angeles office using the
Maintenance Console (PC programming software of the PBX). After the PBX in the Los Angeles
office has been fully programmed, repeat the procedure for the PBX in the Chicago office with the
appropriate setting values.
Notes
• It is assumed that you have already installed the Maintenance Console (KX-TDA100/KX-
TDA200: KXTDA Maintenance Console; KX-TDA600: KX-TDA600 Maintenance Console) in
your PC.
• The screenshots shown in the installation procedure are based on the KX-TDA600
Maintenance Console.
• The contents and design of the software are subject to change without notice.
42 Getting Started
1. Start the Maintenance Console from the Start
menu.
2. a.
Type the Installer Level Programmer Code
(default: INSTALLER).
b.
Click OK.
Click Connect → RS-232C or USB.
3. a.
b.
In the next screen, type the system password
for installer (default: 1234).
c.
Click OK.
The system menu appears.
a.
4.
Under Configuration, click Slot.
b.
Move the mouse pointer over the installed
VoIP Gateway Card to display the menu of
options.
c.
Click Port Property.