Table of Contents
Advertisement
6 Using the System
6.8.8 Indoor unit settings
You can use this screen to check the air conditioning capacity of indoor units, and to set the capacity.
Normally you do not need to change settings with this screen.
Exercise care when changing settings, because improper settings can prevent accurate
distribution.
Procedure
Select 6.Auxiliary settings in the main menu and 8.I/D unit settings in the sub menu.
*When "No Distrib." is selected, this screen is not accessible. (see
1 Select the link system to display.
1.Zone name
2.ZoneNo./Mng.target
3.Program timer
4.Ten.Ho/TimerSp.Day
5.Prohibit R/C
1.Status/Control
6.Distribution time zone
2.Total data/Cut-off
7.Special distrib. day
3.Distrib. ratio/Usage
8.I/D unit settings
4.Maintenance/Test Run
9.Other settings
5.Initial settings
10.WEB settings
6.Auxiliary settings
11.User settings
2
1
2 To change a capacity setting, touch an item in the capacity column, and enter a kW capacity
from 0 to 999.9 in the numeric keypad window which appears.
3 Touch Set to con rm the setting.
Or Auto to cancel it. (The capacity value will restore the received level)
If you have changed the capacity, an asterisk ( ) appears to the left of the value.
4 Touching the heater capacity column for the indoor unit having an electric heater will have a soft
ten-key for the heater capacity setting displayed. Input numbers 0.0 to 100.00 by kW. However,
these are effective only for loaded distribution settings.
64
6
6
8
8
6 Using the System
Main
Sub
6.8.9 Other settings
5
1
5
1
Main
Sub
)
3
6.8.9.1 Checking the connection con guration
4
You can use this screen to register passwords, initialize data, and make power saving settings for
the LCD display.
Procedure
Select 6.Auxiliary settings in the main menu and 9.Other settings in the sub menu.
1.Zone name
2.ZoneNo./Mng.target
3.Program timer
4.Ten.Ho/TimerSp.Day
5.Prohibit R/C
1.Status/Control
6.Distribution time zone
2.Total data/Cut-off
7.Special distrib. day
3.Distrib. ratio/Usage
8.I/D unit settings
4.Maintenance/Test Run
9.Other settings
5.Initial settings
10.WEB settings
6.Auxiliary settings
11.User settings
1 Touch the Chk con g. button to check the connection con guration of the system.
You should do this after adding or deleting units, changing addresses, and so on.
If the system con guration has changed, cut-off processing and con rmation of the system
processing messages appear. For details, see "6.9 System Con guration Changes".
Up to 10 minutes may be required to check the system con guration.
65
6
9
6
9
Main
Sub
1
2
3
4
5
6
7
8
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Chapters
Table of Contents
