Connecting An Ipod - Kenwood KRF-V7300D Instruction Manual

Connecting an iPod

The PNC-iP120 (optional) is necessary to connect an iPod to this unit.
For the usable iPod models, see < iPod models usable with this unit> 7.
L
R
PLAY IN PLAY IN REC OUT
AUX CD MD/TAPE
ANTENNA
AM GND
+
‒
R
RED
SPEAKER A
FRONT SPEAKERS (6 – 16 )
Display when an iPod is connected
When an iPod is connected and the iPod input source is selected,
the display shows the connection status of the iPod.
"Reading" (Blinking):
iPod is being recognized.
"Connected" :
iPod has been recognized. Now this unit can control the
iPod.
"Connect Error" :
The connection is erroneous.
➡ Disconnect the iPod and connect it again.
The iPod in use is not compatible with this unit.
➡ Connect an iPod compatible with this unit by referring
to < iPod models usable with this unit> 7.
The software version of the iPod may be obsolete.
➡ Update the software version of the iPod by referring to
< iPod models usable with this unit> 7.
The battery is low.
➡ Wait until the battery is charged.
"Disconnect" :
The iPod is disconnected.
24
KRF-V9300D/KRF-V8300D/KRF-V7300D
AUDIO
CENTER
AUTO ROOM EQ
MIC IN
PLAY IN REC OUT PLAY IN PLAY IN FRONT SURROUND SUB WOOFER
SUB WOOFER
VIDEO1 VIDEO2 DVD/6CH IN PRE OUT
FM 75
L R L
WHITE
SPEAKER B
iPod
C
5V 500mA
V
VIDEO
VIDEO1 IN DVD IN
VIDEO1 OUT S-VIDE
iPod
+
500mA
5V
‒
GREEN
CENTER
SUR
PNC-iP120 (optional)
• Turn this unit OFF (standby mode) before connecting the iPod.
• Insert the iPod connection cable all the way, until it clicks.
• To disconnect the iPod, hold the release buttons on both sides
of the connector of the iPod connection cable and pull the
connector. To prevent damage, do not pull the connector with an
excessive force.
• While the iPod is connected to this unit, the iPod can be
controlled from this unit or the remote control unit provided with
it. When the iPod is connected to this unit, it cannot be used to
control its operations.
Release buttons