Krf-V9300D And Krf-V8300D Speaker Setup -"Auto Setup"(Auto Room Eq) - Kenwood KRF-V7300D Instruction Manual

KRF-V9300D and KRF-V8300D Speaker setup –"Auto Setup"(Auto Room EQ)–
The Auto Room EQ function sets up the optimum home theater
environment by automatically measuring and analyzing the
following properties.
¶ Connected speakers
¶ Distance from each speaker to the listening
position
¶ Size of each speaker
¶ Polarity of each speaker
¶ Reproduce frequency characteristic of each
speaker
¶ Volume level of each speaker
This function uses the setup microphone provided with this unit.
The speakers output high-level test tones during measurement.
Take special care for the neighborhood and sleeping children
when using this function particularly in the nighttime.
1
Connect the microphone to this unit.
CENTER
AUTO ROOM EQ
MIC IN
SUB WOOFER SUB WOOFER
PRE OUT
AUDIO
L
R
PLAY IN PLAY IN REC OUT PLAY IN REC OUT PLAY IN PLAY IN FRONT
AUX CD MD/TAPE VIDEO1 VIDEO2
ANTENNA
AM GND FM 75
+
‒
R L R L
RED WHITE
SPEAKER A SPEAKER B
FRONT SPEAKERS (6 – 16 )
If headphones are plugged in, unplug them.
32
KRF-V9300D/KRF-V8300D/KRF-V7300D
AUTO ROOM EQ
ENTER
MULTI CONTROL
/ / /
CENTER
AUTO ROOM EQ
iPod OPTICAL OPTICAL COAXIAL
MIC IN
DVD
CD(ASSIGNABLE) VIDEO2 DVD
5V 500mA
DIGITAL IN
VIDEO COMPONENT VIDEO
SURROUND SUB WOOFER SUB WOOFER VIDEO1 IN VIDEO2 IN
VIDEO1 IN DVD IN VIDEO2 IN MONITOR OUT
Y CB CR Y CB CR
DVD/6CH IN PRE OUT
VIDEO1 OUT DVD IN
S-VIDEO MONITOR OUT
+
‒
R L R L
GREEN GRAY BLUE TAN BROWN
CENTER SURROUND SURROUND BACK
SURROUND SPEAKERS (6 – 16 )
2
Place the microphone in the listening position.
Place the microphone at the height of the listener's ears.
Do not place any obstacle between the microphone and
the speakers.
3
Enter the Auto Setup mode and start
measurement.
[AUTO ROOM EQ]
Use [MULTI CONTROL 2/3] to select "Calibrate".
[ENTER]
Use [MULTI CONTROL 2/3] to select "Start".
[ENTER]
VIDEO2 IN MONITOR OUT
HDMI
It takes about 2 minutes before the measurement
completes.
The display changes from "Calibrating 1" to "Calibrating 2".
When the measurement completes, the display changes
to "Analyzing", indicating that the measurement results are
being analyzed. In this case, go to step 6.
If the measurement stopped in the middle and a message is
displayed, go to step 4.
4
Check the message and take an action against the
message.
See <If a message is displayed> › and check the
content of the message and follow the instructions.