Resetting The Unit; Opening Up/Closing The Monitor - Sanyo AVC-100 Installation And Operation Manual

RESETTING THE UNIT

To use for the first time, or after replacing the car battery or changing the connections, resetting is
necessary. After detaching the front panel, (zSee p.31) push the t button by using a pointed
object (ex. ball point pen).
t CAUTION
Do not use a needle or push the button too strongly.
Hint ¡When the t button is pushed, all the setting memory are lost and you have to Reprogrammed.
¡It takes about 10 seconds to resetting after the t button is pushed.
¡After the resetting is completed, press the
properly.
27
t button
A
button to confirm that the monitor opens up

OPENING UP/CLOSING THE MONITOR

When turning on the ignition, the unit is power on, and the warning message appears on the screen.
WARNING !
TO AVOID RISK OF ACCIDENT OR
POSSIBLE VIOLATION OF LAWS,
DO NOT OPERATE DEVICE
IF IT IS VISIBLE TO THE DRIVER.
OPENING UP THE MONITOR
1
A
Press button.
: The monitor slides out of the unit and opening up.
CLOSING THE MONITOR
1 A
Press button.
: The monitor retracts automatically, and you can use only the audio functions of the unit.
Hint
This function cannot be operated by the remote controller.
t CAUTION
Do not close your fingers to the monitor while it is opening or closing.
Damage to the unit or injury may result.
A
button
28