Page 1
Drill FD 10VB FD 10SB • Handling instructions FD10VB Read through carefully and understand these instructions before use.
Page 2
<FD10VB> <FD10VB> Trigger switch Adjusting knob High speed Low speed Stopper Lever Right (clockwise) Left (counterclockwise) Drill chuck Chuck wrench Tighten (clockwise) Loosen (counterclockwise) When the point appears, turn lumber over Lumber to be drilled Extra lumber...
A wrench or a key left attached to a rotating part GENERAL SAFETY RULES of the power tool may result in personal injury. e) Do not overreach. Keep proper footing and balance WARNING! at all times. Read all instructions This enables better control of the power tool in Failure to follow all instructions listed below may result unexpected situations.
5. Do not touch the bit during or immediately after PRECAUTIONS ON USING DRILL operation. The bit becomes very hot during operation and could cause serious burns. 1. Wear ear protectors with impact drills. 6. When placing the drill on the floor, make sure that Exposure to noise can cause hearing loss.
If the replacement of the supply cord is necessary, will also be made. (Fig. 5) this has to be done by Hitachi Authorized Service A wood-working drill need not be pressed strongly Center in order to avoid a safety hazard.
Page 12
Hitachi Koki Co., Ltd. Code No. C99071823 G Printed in China...