Tool Retainer; Adjusting Mechanism For Tool Swivel Angle - Hitachi H 25PV Technical Data And Service Manual

8-4. Tool Retainer

The Model H 25PV is equipped with a slide-type tool retainer. Tools can be attached and detached just by pulling
grip. While pulling grip in direction, insert the tool in the hole of the front cap (Fig.6). Adjust the groove
1
position by turning the tool and push it in to the end. Lock the tool by returning grip back to the original position.
Make sure it is locked completely by pulling tool in 2 direction (Fig. 7).
Front cap
Tool shank
1
2
Grip
Fig. 6 Fig. 7

8-5. Adjusting Mechanism for Tool Swivel Angle

Sliding the lock sleeve in the direction , turn the grip in the direction as shown in Fig. 8. Then the tip angle of
1 2
the tool can be adjusted in eight levels. After adjustment, release the lock sleeve and check for secure locking by
turning the grip.
2
1
Grip
Lock sleeve
Fig. 8
--- 10 ---