Panasonic AW-HE130W Operating Instructions Manual page 92

Web screen configurations (continued)
Recommended network setting for internet
Perform the recommended settings to connect the camera to the
Internet.
Clicking the "Set" button displays a dialog box telling the user that
item settings will be changed. After confirming this, click the "OK"
button.
• Camera image's "JPEG/H.264" tab
JPEG(1)
Image capture size: 640×360
JPEG(2)
Image capture size: 320×180
JPEG(3)
Image capture size: 160×90
H.264(1) • H.264(2) • H.264(3) • H.264(4)
Internet mode (over HTTP): On
Transmission priority: Best effort
H.264(1)
Image capture size: 1280×720
Max bit rate (per client): Max1024 kbps, Min256 kbps
H.264(2)
Image capture size: 640×360
Max bit rate (per client): Max1024 kbps, Min128 kbps
H.264(3)
Image capture size: 320×180
Max bit rate (per client): Max1024 kbps, Min128 kbps
H.264(4)
Image capture size: 160×90
Max bit rate (per client): Max1024 kbps, Min128 kbps
• "Network" tab in the Network setting screen
Common IPv6/v4
Max RTP packet size: Limited (1280 byte)
HTTP max segment size(MSS): Limited (1280 byte)
92
Advanced network setting screen
„
Click the "Advanced" tab in the network setting screen (→page@@,
page @@)
Settings relating to the NTP, UPnP, HTTPS, SNMP, and Diffserv
functions are performed here.
Click the links to each item to move to the respective setting page.
z NTP
Settings relating to the NTP server address and port No. are
performed here.
NTP server address setting
Select the method to acquire the NTP server address.
Setting value:
Auto Acquires the NTP server address from the DHCP server.
Sets the address by inputting the NTP server address in
Manual
"NTP server address".
Factory settings: Manual
<NOTE>
• To acquire the NTP server address from the DHCP server,
"Network Settings" (→page @@) must be set to either "DHCP",
"Auto(AutoIP)" or "Auto(Advanced)" in the "Network" tab of the
network setting screen.
NTP server address
When "Manual" is selected in the "NTP server address setting", input
the IP address or host name of the NTP server.
Maximum number
1 to 128 half-size characters
of characters
Characters that
Half-size alphanumeric characters, half-size symbols
can be entered
Factory settings: blank
<NOTE>
• To input the "NTP server address" host name, the DNS setting must
be selected on the Network screen of the Network settings. (→page
@@)
NTP port [1 to 65535]
Input the port No. of the NTP server.
Port Nos. that can be selected 1 to 65535
The following port numbers are used by the unit so they cannot be
used.
20, 21, 23, 25, 42, 53, 67, 68, 69, 80, 110, 161, 162, 443, 995, 10669,
10670
Factory settings: 123