HP t620 Troubleshooting Manual page 26

13.
Slide the new SODIMM (1) into the socket at approximately a 30° angle, and then press the
SODIMM into the socket (2) so that the latches lock it in place.
NOTE:
the tab on the memory socket.
14. Hold the memory compartment cover with the fiber NIC slot toward the front of the computer, and
then set the memory compartment cover (1) over the SODIMMs.
15.
If a fiber NIC is installed, move the cable carefully into the slot in the memory compartment cover.
16.
Line up the screw holes in the memory cover with the screw posts in the chassis, and then fasten
the two screws (2) with the springs to secure the memory compartment cover.
18 Chapter 2 Hardware changes
A memory module can be installed in only one way. Match the notch on the module with