Table of Contents
Advertisement
Opening the free arm
For threading the yarns the free arm 0 must be
opened.
1. Pull the arm support 9 off to the side.
2. Open the front flap 8.
3. Press the release lever "PUSH" f and, at the
same time, pull the free arm 0 downwards.
Threading yarns into the looper
Attention!
Before starting to thread yarns, ALWAYS place the
power switch 7 at OFF and remove the plug j.
This will prevent an unintentional starting of the ap-
pliance. If you do not, you run a risk of serious injury!
Correct threading is important, so that the stitches
are not irregular and that the yarn does not break.
On the inner side of the front flap 8 there is a guide
to threading. Additionally, the thread guides are
marked in various colours.
In the accessory box you will find pincers, the use
of which helps make threading easier.
Threading takes place in this sequence:
Upper looper s (green)
1. First step:
Lower looper d (blue)
2. Second step:
3. Third step:
Right needle (yellow)
4. Fourth step:
Left needle (red)
For simplification, the individual steps are numbered
on the illustrations (1
1. Open the front flap 8 and free arm 0.
2. Turn the handwheel 6 to yourself until the looper s
is in the most favourable position for threading.
3. Thread the upper and lower looper yarns as
shown.
Thread tree 1 (on the right)
Thread guide r and thread guide plate t
(on the right)
Note:
The yarn must lie correctly between the two discs of
the thread tension selector 2/e.
- 7 -
q
w
e
r
, 2
, 3
, 4
, ...).
Hide quick links:
Advertisement
Table of Contents
