LG LRN3040N Series Owner's Manual page 29

-
GOV (ONVIF only): It means "Group of VOPs". The VOP is an
image frame in the MPEG-4 video stream. Edit the value of
GOV from 1 to 30.
- Quality: Select the Quality.
-
Stream Quality (LGE only): If the [Quality] option set to VBR,
this option is displayed. Select the stream quality from the
drop down box, the camera supports five types. (Highest,
High, Medium, Low and Lowest)
- Bitrate: If the [Quality] option set to CBR, this option is
displayed. Edit the bit rate value from 256 kbps to 10 240
kbps.
- Compession (AXIS only): Enter the compression ratio of
video. The lower value you set up, the higher definition
picture you get.
• Delete: Click the check box of the desired channel and then
press the [Delete] button. Registered channel of IP Camera will
be deleted.
To register the IP device automatically
1. Click the [AUTO] button.
2. The search window will be displayed and start to search the IP
device automatically. By stopping or restarting the search, click
[Stop] or [Refresh] button.
3. Click the check box of desired device.
4. Enter the [User Name] and the [Password] and then click the
[Add] button. When you select several channels, channels are
assigned same ID and password.
5. Confirm the result of authentication on the [Verify] option.
• O: The verification is valid.
• X: The verification is invalid. Check the ID and password
again.
• XX: Connection failed.
6. Click the check box of confirmed cameras. Selected cameras are
registered channel in order.
7. Click the [CLOSE] button to exit the window.
NOTE
The information of search result such as model name, MAC
and others may not be shown depending on security level or
connection information.
To register the IP device manually
1. Click the [MANUAL] button.
2. Enter the IP address.
3. Click the check box of desired device.
4. Enter the [User Name] and the [Password] and then click the
[Add] button. When you select several channels, channels are
assigned same ID and password.
5. Confirm the result of authentication on the [Verify] option.
6. Click the check box of confirmed cameras. Selected cameras are
registered channel in order.
7. Click the [CLOSE] button to exit the window.
NOTE
• The Supported IP camera specifications.
Specification
Driver LGE, AXIS, ONVIF
Recording mode Continuous, Instant, Motion,
Sensor
Video Codec H.264, MPEG4, MJPEG
Audio recording and Support
playback
Resolution CIF, Half D1(2CIF), D1(4CIF), UXGA,
720p, 1080p (Up to 5M)
Stream LGE (Master-0, Slave-0)
ONVIF (The stream that is
supported from camera)
AXIS (H.264, MPEG4, MJPEG)
PTZ Support
Sensor/Motion input Support
• It takes time to search IP devices and the necessary time
depends on the network environment.
Installation
Description
29
3