Table of Contents
Advertisement
1-C Battery Installation
The unit requires 3 AA (LR6) size alkaline batteries (not included).
The battery life is about 30 hours. (Based on a usage duty of 5%
receive, 5% talk, 90% standby.)
)
1 Pull down the hook and
remove the cover.
(3-C)
Jack
tton
3 Close the cover.
n
on
Button
≥ Make sure that the unit is powered OFF before replacing the
batteries.
A, 3-B)
Battery precautions:
The batteries should be used correctly, otherwise the unit may be
damaged by battery leakage.
≥Do not mix different types of batteries.
≥Do not charge, short-circuit, disassemble or heat batteries, and do
not dispose of batteries in fire.
≥Remove all the batteries when replacing.
Battery strength:
You can check the battery strength on the display (see below) while
the unit is in use. If the unit
beeps intermittently and "
y call
flashes on the display, replace
3-E).
all the batteries with new ones.
s ON
≥ If the unit is left on when the battery is LOW, everything, except
the flashing "
", will disappear from the display. Only the
(POWER)
button can be operated to turn the unit off.
the
≥ Battery life may vary depending on usage conditions and ambient
C).
temperature.
1-D Belt Clip
You can hang the unit on your belt or pocket using the belt clip.
To attach the belt clip
group
ones
nel
2 Install (or replace) the
batteries using the correct
polarity (r, s).
-
-
-
3
2
2
1
+
+
1
Full
Medium
"
To remove the belt
clip
¤
Getting Started
1-E Adjusting the Antenna
The antenna rotates 360 degrees.
You can adjust the antenna to three
different click positions.
For best performance, the antenna
should be used in the vertical
position.
+
1-F Turning the Power ON/OFF
1 Press and hold
≥The display will appear.
2 To turn the power off, press and hold
(POWER)
until the display disappears.
1-G Programming Summary
You can program the following functions. See the corresponding
section number for details.
Each time you press (MENU), the display will change as
follows.
Low
(flashing)
Press (›) or (‹) for the desired settings.
When finished, press (TALK) or wait for 10 seconds.
≥ You can exit the programming mode any time by pressing (TALK)
or waiting for 10 seconds.
(POWER)
.
The display shows the current channel and
group code.
To select the operating channel, see 2-A.
To select the group code, see 2-B.
To select the VOX sensitivity, see 6-A.
To change the call tones, see 3-D.
To turn on/off the vibratory call, see 3-E.
(KX-TR325 only)
To turn on/off the scrambling function, see
5-C. (KX-TR325 only)
To select the auto power off mode, see 5-B.
Section 1
Advertisement
Table of Contents
