Table of Contents
Advertisement
7
Things You Should Know
n 6
7-B Before Requesting Help
Problem
for
You press (POWER) to
dium).
power the unit ON, but
the unit does not work.
Your message cannot
be transmitted.
The other party's
message cannot be
received.
r
er
cket
You cannot change
channel/code settings.
ack is
7-C Specifications
Using
nit.
Operating frequency
e
Power requirements
n 7
External power source
Alkaline battery life
Design and specifications are subject to change without notice.
and
Channel frequency chart
s
Ch
Freq.
1
462.5625
2
462.5875
3
462.6125
4
462.6375
5
462.6625
Remedy
≥Reposition or replace batteries (1-C).
≥Make sure the unit is unlocked (5-A).
≥Make sure (TALK) is firmly pressed
and held when you transmit.
≥Reposition or replace batteries (1-C).
≥You cannot send a message while
receiving using the Headset Mic
(KX-TRA10C). Wait until the other
party stops talking.
≥Change the VOX sensitivity according
to the noise around you in the VOX
mode (6-A).
≥Make sure the other party's channel/
code settings are the same as yours.
≥Make sure (TALK) is not inadvertently
being pressed.
≥Reposition or replace batteries (1-C).
≥Obstructions, operating indoors or in
vehicles, may interfere with
communication. Change your location
and try again.
≥Hold the unit near your ear to hear the
message from the ear speaker when
the flip is open.
≥Change the VOX sensitivity according
to the noise around you in the VOX
mode (6-A).
≥Make sure the unit is unlocked (5-A).
462.5625–462.7125 MHz
467.5625–467.7125 MHz
14 channels
38 codes
4.5 V DC,
3 AA (LR6) size alkaline batteries
(not included)
DC IN 4.5 V jack accepts:
12 V negative ground car battery with Car
DC Power Adaptor (optional)
Approx. 30 hours (Based on a usage duty
of 5% receive, 5% talk, 90% standby)
(unit: MHz)
Ch
Freq.
Ch
Freq.
6
462.6875
11
467.6375
7
462.7125
12
467.6625
8
467.5625
13
467.6875
9
467.5875
14
467.7125
10
467.6125
Problem
Other conversations or
≥Confirm the group code setting (2-B).
noise on a channel is
If the setting is "0" (OFF), reprogram
heard when receiving.
the same group code as the other
party, and try again.
≥Shared channel or group code may be
in use. Try another.
Limited Talk Range
≥Steel/concrete structures, heavy
foliage and use in buildings or vehicles
will decrease range. Check for clear
line of sight to improve transmission.
≥Wearing the unit on your body, such
as in a pocket or on a belt, will
decrease range. Change location of
the unit.
Static, sound cuts
≥You are too close to the other party.
in/out, fades.
You should be at least 10 feet apart.
Interference emits
Increase your distance.
when transmitting.
≥You are too far from the other party.
Obstacles interfere with transmission.
Range is maximized in flat, open
areas.
The transmission
≥The unit automatically returns to the
suddenly stops while
standby mode if more than
sending messages
60 seconds pass while sending
using (TALK).
messages using (TALK). To continue,
press and hold (TALK) again.
"
" flashes on the
≥Reposition or replace batteries (1-C).
display.
The display is dim.
≥Reposition or replace batteries (1-C).
7-D Important and Other Information
NOTICE:
Operation is subject to the condition that this device may not cause
harmful interference.
Privacy of communications may not be ensured when using this unit.
≥Environment—do not leave the unit in a place where the
temperature is less than –10°C (14°F) or greater than 50°C
(122°F), such as in areas of direct sunlight, heating radiators or
closed automobiles. Avoid excessive smoke, dust, mechanical
vibration or shock. Keep the unit away from magnetic cards, such
as bank cards, telephone cards, etc., as the magnet in the unit
may cause the data on the card's magnetic strip to be erased.
≥For safe motor vehicle operation—please do not use the unit
while driving. Either stop your vehicle or allow a passenger to use
the unit.
≥Medical—consult the manufacturer of any personal medical
devices, such as pacemakers, to determine if they are adequately
shielded from external RF (radio frequency) energy. (The unit
operates in the frequency range of 462.5625 to 462.7125 MHz and
467.5625 to 467.7125 MHz, and the power output level is up to
0.5 watts.) Do not use the unit in health care facilities if any
regulations posted in the area instruct you not to do so. Hospitals
or health care facilities may be using equipment that could be
sensitive to external RF (radio frequency) energy.
≥Routine care—wipe the unit with a soft cloth. Do not use benzine,
thinner, or any abrasive powder.
≥If there is any trouble—consult an authorized Panasonic Factory
Servicentre.
¤
Things You Sho
Remedy
Advertisement
Table of Contents
