Unit Number Check - Panasonic WJ-HDE300 Instruction Manual

● Unit Number Check
How to check the unit number
Each extension unit is given a unit number depending
on the connected position. Refer to ■ Connections of
this manual for the recommended connection form and
the unit numbers given to the respective extension
units.
Do the following to check which unit numbers are given
to the extension units.
Important
• Do not change the connections of the extension
units after the
Otherwise, the recorder will fail to recognize the
extension units.
1 SAFETY MODE ON
Select ON for HD Safety Mode and press the SET but-
ton.
SETUP MENU
System Recording
Advanced
Switcher Display
1
REC Rate
160GB 160GB
MAIN
15000h 15000h
Disk Info
160GB 160GB
EXT1
Version Info 15000h 15000h
160GB 160GB
EXT2
Disk End Mode
15000h 15000h
160GB 160GB
EXT3
Disk Capacity
15000h 15000h
160GB 160GB
EXT4
Date Delete
15000h 15000h
160GB 160GB
EXT5
15000h 15000h
160GB 160GB
EXT6
Event Log
15000h 15000h
160GB 160GB
EXT7
Error Log
15000h 15000h
Access Log
■
Warning for Disk Life Time
■
Quick Menu
HDD Safety Mode
→ The recorder will restart and the HDD SAFETY
MODE window will be displayed.
system has been operated.
Event Schedule
LIVE
Comm Maintenance
2 3 4
Remaining
Normal REC Area 1800GB
160GB 160GB Event REC Area 1200GB
15000h 15000h
Copy Area 1000GB
160GB 160GB
1
Copy (Rear)
1000GB
15000h 15000h
160GB 160GB 2
Copy (Front) 1000GB
15000h 15000h
160GB 160GB
15000h 15000h
160GB 160GB
15000h 15000h
160GB 160GB
15000h 15000h
160GB 160GB
15000h 15000h
30000h
ON
SET

2 Unit number check

• Confirm that the HDD POWER indicators on the
front panel of the extension units have gone out.
• On the front panel of the recorder, press the
Camera Selection buttons from [1] to [7] in order.
1
5
→ All the HDD access indicators of the respective
unit will be lit red for 5 seconds. For example,
when the button [1] is pressed, the HDD access
indicators on the extension unit #1 will be lit.
HDD 1 HDD 2
3 SAFETY MODE OFF
Select OFF on the HDD SAFETY MODE window and
press the SET button.
→ The recorder will restart. After 3 or 5 minutes of
system check, it will run in normal operation
mode.
Note: The HDD access indicator that is lit red or blink-
ing due to failure of the hard disk in RAID5 will keep
its state while the other indicators of the unit are lit
red to display the unit number.
2 3 4
SEQ
6 7
HDD 3 HDD 4
SET
25