Installation And Removal; Demolition Digging Boom Installation And Removal; Procedure For Installation And Removal Of Demolition Digging Equipment - Komatsu PC350LC-8 Operation & Maintenance Manual

INSTALLATION AND REMOVAL

INSTALLATION AND REMOVAL

DEMOLITION DIGGING BOOM INSTALLATION AND REMOVAL

The Komatsu High Reach Demolition work equipment can be replaced by purpose built Komatsu Demolition Dig-
ging Equipment. The Demolition Digging Equipment allows easy removal and separation of demolished material.
q Make sure that all work equipment is safely supported or held and will not fall. Attach a lifting device
or support of correct rating, to allow extraction of disconnected piece when ready.
q Make sure that the supports used will support the work equipment even if accidentally pushed by the
machine.
q Follow these instructions step by step, in sequence. Do not omit any of the actions. Do not perform
the actions in a different order.
REMARK
A Komatsu demolition work equipment support system is available through your dealer. This system should be
used to hold the demolition work equipment when it is removed.
PROCEDURE FOR INSTALLATION AND REMOVAL OF DEMOLITION DIGGING EQUIP-
MENT.
REMOVAL OF HIGH REACH WORK EQUIPMENT
1. There must be plenty of room available to manoeuvre the
machine for removal of work equipment. Make sure the oper-
ations are carried out in a flat, level, spacious area.
2. Fit the transport pin, holding the demolition equipment arm to
the demolition boom.
With the transport pin in position, do not operate the arm or
mid link. Significant damage to the machine will result.
3. With the high reach work equipment in the normal travel posi-
tion (see diagram), move the machine into a position where
there is plenty of room to access the work equipment, even in
the lowered position.
7-30
CAUTION
HIGH REACH DEMOLITION MANUAL
WARNING
transport pin
Travel Posture
7
7
7