Panasonic KX-TDE100 Programming Manual page 19

7. When country/area data do not match:
a.
Click OK to replace the country/area data of the PBX. Replacement may take several minutes to
complete.
b.
Follow the procedure described in Section 3.16.1 Starting the PBX (for KX-TDE100/
KX-TDE200) or Section 3.15.1 Starting the PBX (for KX-TDE600) in the Installation Manual and
restart the PBX.
c.
Repeat step 5 to reconnect the Maintenance Console to the PBX.
8. Follow the instructions of the Quick Setup wizard for the basic items in Quick Setup.
9. On the IP addressing information screen, the information for the IPCMPR/IPCEMPR card can be
assigned automatically through a DHCP server or entered manually.
Note
If you change any information on this screen and click Apply, the PBX will need to be reset.
When using a DHCP server:
a.
Select Enable for the DHCP Client setting.
b.
Click Apply.
Note
The boxes will turn grey and the IP addresses will
be assigned automatically after the PBX is reset.
When not using a DHCP server:
a.
Select Disable for the DHCP Client setting.
b.
For KX-TDE100/KX-TDE200, type the IP address of
the IPCMPR card in the IP Address for IPCMPR
Card box. For KX-TDE600, type the IP address of the
IPCEMPR card in the IP Address for IPCEMPR
Card box.
*1
c.
In the IP Address for VoIP-DSP box, type the IP
address of the DSP16 or DSP64 card.
d.
In the Subnet Mask box, type the subnet mask
address of the network.
e.
In the Default Gateway box, type the IP address of
the default gateway.
f.
Click Apply.
After Quick Setup is completed, if the IP addressing information was not changed, and if a V-IPEXT card
was installed during setup, the IP-PT registration screen is displayed. For information on registering IP-PTs
to the PBX, see 3.15 [1-1] Slot—Port Property - Virtual IP Extension.
You may now begin programming the PBX.
Notice
•
Do not change the IP addresses of the IPCMPR/IPCEMPR and DSP cards once IP telephones are
registered to the PBX using these IP addresses.
The IP telephones will not operate properly if these IP addresses are changed.
•
A DHCP server must be able to use a "client identifier" option specified by RFC 2131.
•
The PBX will not start properly if the IP addresses cannot be assigned automatically by the DHCP
server when DHCP Client is set to Enable. In this case, you need to consult your network administrator
because the DHCP server on your network may not be running or a network failure may have occurred.
*2
*3
*4
1.2.1 Installing and Starting the Maintenance Console
PC Programming Manual 19