Table of Contents
Advertisement
Tape Operation
Search System
For each recording, an invisible index mark is
placed on the tape. A program index and
information are also included for timer
recordings. These marks are used to access or
scan recordings.
Index Search
1
2
■ ■ ■ ■ ■ To Calculate Index Number
Example 1:
To go to rec. 2 from rec. 4, enter 3 and press
REW.
1
2
3
4
Example 2:
To go to rec. 6 from rec. 2, enter 4 and press
FF.
1
2
3
4
NOTE:
indicates start points of each recording.
Note
• If Index Search is started very close to an index
mark, that index mark may not be counted in the
search.
30
AG-VP320-3(VCR)_24-35.p65
Zero Search
To quickly return to a specified tape location.
1
2
Press SEARCH*
to display SEARCH
in Stop or Play
mode, and then
3
press NUMBER
keys to select
recording number.
• To calculate number,
4
see below.
Press FF/SLOW+ or
REW/SLOW- on the
5
remote to start
search.
Play begins at
search end.
To search forward or
back 1 index, press
FF/SLOW+ or REW/
SLOW- on the
remote while screen
Commercial Skip
at left is displayed
(10 sec.).
DECK fast forwards (skips) over 1, 2, or 3
• To cancel, press
minutes of recorded tape as desired.
PLAY or STOP.
1
5
6
7
5
6
7
30
Press DISPLAY during play to display
Counter.
Press COUNTER
RESET on remote at
desired position to
reset to "0:00:00".
Continue to record, playback etc.
Press STOP.
Press CM/ZERO
in Stop mode to start
Zero Search.
• DECK will go into FF or REW mode and stop
at the last point the Counter was set to
0:00:00.
Press CM/ZERO in Play mode.
• The skip time can be changed by pressing
CM/ZERO repeatedly as shown by the figure
below.
PLAY
1st Press
1 min Skip
2nd Press
2 min Skip
3rd Press
3 min Skip
• No indication appears on-screen.
2005/05/18, 16:11
Advertisement
Table of Contents
