Channel/Clock Settings When Tv Guide On Screen System Is Not Used; Auto Channel/Clock Settings - Panasonic DMR-E85H DIGA Operating Instructions Manual

Channel/Clock settings when TV Guide On Screen system is not used

Refer to the control reference on page 40.
Preparation:
If the television program list has already been downloaded, return the unit to the factory preset condition using the steps indicated below.
When the unit is on and stopped
Press and hold [ CH] and [
The unit turns off.
Press [ DVD POWER] to turn the unit on.
Complete the TV Guide On Screen system setup (until [ENTER] is pressed after the "Watch TV" message screen is displayed).
[Note]
You can set timer recording only manually after you set the unit with "Auto Channel Setting".

Auto channel/clock settings

1
Press [SETUP].
2
Press [ , ] to select "Channel" and
press [ ].
3
Press [ , ] to select "Auto Channel
Setting" and press [ENTER].
4
Press [ , ] to select "Yes" and
press [ENTER].
5
Press [ENTER].
Auto Channel Setting starts. This takes a few minutes.
The unit then proceeds with Auto Clock Setting. The time is
displayed when finished.
Auto Clock Setting
SETUP
Auto Clock Setting is complete.
Channel
Set Up
4/4/2002 12:15 AM
Disc DST............. ON
TIME ZONE.... CST
Video
Audio
DST, Daylight Saving Time, shows the summertime setting.
TIME ZONE shows the time difference from Greenwich
meantime (GMT).
EST (Eastern Standard Time)
CST (Central Standard Time)
MST (Mountain Standard Time)
PST (Pacific Standard Time)
AST (Alaska Standard Time)
HST (Hawaii Standard Time)
For other areas: xx hr
If the Auto Clock Setting does not start automatically, select
"Auto Clock Setting" from the "Set Up" tab.
If the time was not set correctly, use manual clock setting
(➡ page 11) or time zone adjust.
6
Press [ENTER].
To exit the screen
Press [SETUP].
To return to the previous screen
Press [RETURN].
CH] on the main unit for about five seconds.
GMT 5
GMT 6
GMT 7
GMT 8
GMT 9
GMT 10
The unit configures channels according to the Antenna
System settings as follows.
Antenna system
VHF
TV
UHF
VHF
CATV LOW BAND
CATV MID/SUPER BAND
CATV
CATV HYPER BAND
ULTRA BAND
SPECIAL CATV CHANNEL
Time Zone Adjust
Adjust the time zone ( 1 or 1) if it was not set correctly with auto
clock setting.
You cannot change this setting if you set the clock manually.
1
Press [SETUP].
2
Press [ , ] to select "Set Up" and
press [ ].
3
Press [ , ] to select "Time Zone
Adjust" and press [ENTER].
Time Zone Adjust
SETUP
Channel
Set Up
Disc
Video
4
Press [ , ] to select " 1" or " 1"
and press [ENTER].
Band Channel
2–13
14–69
2–13
95–99
14–36
37–65
66–94
100–125
1
j1
0
i1
RQT7305
43