Hitachi G 18SE3 Handling Instructions Manual
Hide thumbs
Also See for G 18SE3:
- Technical data and service manual (55 pages) ,
- Handling instructions manual (48 pages) ,
- Safety instructions and instruction manual (52 pages)
Table of Contents
Advertisement
Quick Links
Disc Grinder
Model G 18SE3 • G 18SG2 • G 23SF2
G 23U2 • G 23SE2 • G 23UB2
Handling instructions
NOTE:
Before using this Electric Power Tool, carefully read through these
HANDLING INSTRUCTIONS to ensure efficient, safe operation. It
is recommended that these INSTRUCTIONS be kept readily
available as an important reference when using this power tool.
G23SE2
Advertisement
Table of Contents
Related Manuals for Hitachi G 18SE3
Summary of Contents for Hitachi G 18SE3
-
Page 1: Handling Instructions
Disc Grinder Model G 18SE3 • G 18SG2 • G 23SF2 G 23U2 • G 23SE2 • G 23UB2 Handling instructions G23SE2 NOTE: Before using this Electric Power Tool, carefully read through these HANDLING INSTRUCTIONS to ensure efficient, safe operation. It is recommended that these INSTRUCTIONS be kept readily available as an important reference when using this power tool. -
Page 2: General Power Tool Safety Warnings
Carrying power tools with your finger on the switch GENERAL POWER TOOL SAFETY WARNINGS or energising power tools that have the switch on invites accidents. WARNING d) Remove any adjusting key or wrench before turning Read all safety warnings and all instructions. the power tool on. -
Page 3: Safety Warnings Common For Grinding Or Abrasive Cutting-Off Operations
j) Hold power tool by insulated gripping surfaces only, SAFETY WARNINGS COMMON FOR when performing an operation where the cutting GRINDING OR ABRASIVE CUTTING-OFF accessory may contact hidden wiring or its own OPERATIONS cord. Cutting accessory contacting a”live” wire may make a) This power tool is intended to function as a grinder exposed metal parts of the power tool “live”... -
Page 4: Safety Warnings Specific For Grinding And Abrasive Cutting-Off Operations
d) Use special care when working corners, sharp edges c) When wheel is binding or when interrupting a cut etc. Avoid bouncing and snagging the accessory. for any reason, switch off the power tool and hold Corners, sharp edges or bouncing have a tendency the power tool motionless until the wheel comes to to snag the rotating accessory and cause loss of a complete stop. -
Page 5: Specifications
SPECIFICATIONS Model G18SE3 G18SG2 G23SF2 G23U2 G23SE2 G23UB2 Voltage (by areas)* (110V, 220V, 230V, 240V) Input* 2300 W 2500 W 2000 W 2400 W, 2500 W No-load speed 8500 min 6600 min Outer dia. 180 mm 230 mm Wheel Inner dia. 22 mm Peripheral speed 80 m/s... -
Page 6: Practical Grinder Application
5. Ensure that the depressed center wheel to be utilized 4. Switch operation is the correct type and free of cracks or surface defects. Switch ON: Push the locking button forward and Also ensure that the depressed center wheel is then press the switch lever. -
Page 7: Maintenance And Inspection
ONLY be performed by a Hitachi Accordingly, some parts (i.e. code numbers and/or Authorized Service Center. design) may be changed without prior notice. - Page 16 Hitachi Koki Co., Ltd. Shinagawa Intercity Tower A, 15-1, Konan 2-chome, Minato-ku, Tokyo, Japan Code No. C99122515 M Printed in Malaysia...