Assembly - Canon 1130 Service Manual

CHAPTER 6 IMAGE FORMATION SYSTEM
13) Remove the four screws [16], and detach
the developing drive assembly [17].
Take care not to hit the
gear [18] on the drum
shaft.
14) Disconnect the three connectors [19]
found on the top of the multifeeder

assembly.

15) Pull off the three pins [20] at the top, and
shift the partition sheet [21] in the
direction of the arrow.
16) Remove the transfer assembly frame from
the copier.
17) Remove the two screws [22], and remove
the toner receptacle [23].
18) Remove the screw [24], and detach the
face cover [25].
19) Remove the two screws [26], detach the
two positioning pins [27].
6-86
COPYRIGHT © 2002 CANON INC.
[16]
[22]
[27]
CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON)
[17] [18]
[15]
Figure 6-688
[20]
[21]
Figure 6-689
[26]
[21]
[26] [23]
[24]
Figure 6-690
[16]
[19]
[19]
[27]