Table of Contents
Advertisement
Before using for the first time
Setting the rinse aid dosage
You can adjust the rinse aid dosage for
best results.
The rinse aid dosage can be set from
approx. 0-6 ml. It is set to a
recommended setting of approx. 3 ml
at the factory.
If spots appear on crockery and
glassware:
^ Increase the rinse aid dosage.
If clouding or smearing appears on
crockery and glassware:
^ Decrease the rinse aid dosage.
^ Switch the dishwasher off with the
On/Off button K.
^ Press the Start/Stop button in and
whilst holding it in switch the
dishwasher on using the On/Off
button K.
Keep the Start/Stop button pressed in
for at least four seconds until the
"Start/Stop" indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
22
^ Press the programme selector button
three times.
The lowest programme indicator will
flash briefly three times at intervals.
The Wash/Rinse indicator will flash
briefly three times at intervals.
This means that approx. 3 ml of rinse
aid will be used per programme
(factory default setting).
The number of times the Wash/Rinse
indicator flashes tells you the rinse aid
dosage which has been set (see chart).
Rinse aid
in ml
0
1
2
3
4
5
6
^ Use the Start/Stop button to select
the number of flashes which equates
to the rinse aid dosage you want.
Each press of the button moves you
up a level.
The programmed rinse aid dosage is
now stored in memory.
^ Switch the dishwasher off with the
On/Off button K.
"Wash/Rinse"
flash frequency
-
Once
Twice
Three times
Four times
Five times
Six times
Advertisement
Table of Contents
