Kenwood CK 405 G Instructions For Use - Installation Advice page 21

CLEANING THE HOB
Spillage on the hob can usually be removed
by a damp soapy cloth. More obstinate
stains can be removed by rubbing gently
with a soapy nylon (non metal) scouring
pad or mild household cleaner.
FLEXIBLE TUBE
From time to time, check the flexible tube
connecting the gas supply to the cooker.
It must be always in perfect condition;
in case of damage arrange for it to be
replaced by a suitably qualified and
registered installer.
GAS TAPS
If a tap becomes stiff, do not force; contact
your Local Service Centre.
BURNERS AND PAN SUPPORTS
These parts can be removed and cleaned
with appropriate products.
After cleaning, the burners and their flame
spreaders must be well dried and correctly
replaced.
It is very important to check that the burner
flame spreader and the cap have been
correctly positioned. Failure to do so can
cause serious problems.
Check that the electrode "S" (figs. 8.1,
8.3) next to each burner is always clean to
ensure trouble-free sparking.
Check that the probe "T" (figs. 8.1, 8.3) next
to each burner is always clean to ensure
correct operation of the safety valves.
Both the probe and ignition plug must
be very carefully cleaned.
Note: To avoid damage to the electric
ignition do not use it when the burners
are not in place.
CORRECT REPLACEMENT OF THE
AUXILIARY, SEMI-RAPID AND RAPID
BURNERS
It is very important to check that the burner
flame distributor "F" and the cap "C" have
been correctly positioned (see figs. 8.1,
8.2) - failure to do so can cause serious
problems.
CORRECT REPLACEMENT OF THE
TRIPLE RING BURNER
The triple ring burner must be correctly
positioned (see fig. 8.5); the burner rib
must be enter in their logement as shown
by the arrow (see fig. 8.3).
Then position the cap "A" and the ring "B"
(figs. 8.4, 8.5).
The burner correctly positioned must not
rotate (fig. 8.4).
21