Stage I - Phone Preparation; Step 1 - Charge Battery; Step 2 - Enable Security - Motorola AIR-TRAK Setup Manual

Stage I – Phone Preparation
Objective: Before installing and running the tracking application on your phone, some
preparation is required to configure the handset. The following steps will guide you through the
process of making you handset ready to receive and run the Air-Trak application.

Step 1 - Charge battery

1- Remove the battery door.
2- Insert the top of the battery into the battery area.
3- Replace the battery door and press it gently until you hear a click.
4- Plug the phone's charger into an electrical outlet.
5- Plug the other end of the charger into the accessory connector.
6- Proceed on once the battery is fully charged.
Step 2 - Enable security setting
1- From the idle screen, press the menu button.
2- Scroll to Net and press OK.
3- If the phone prompts you with the message 'security is not enabled' proceed with enabling
security.
4- If the phone does not prompt you with the message 'security is not enabled' proceed with the
following steps.
a. Press and hold the menu key down until you get Browser Menu on the screen.
b. Scroll down to Advanced and press OK.
2- Scroll to Restart UP Browser and press OK. If the phone does not ask you to enable
security, then security has been enabled.
Step 3 - Verify that the phone date and year settings are correct
1- From the idle screen, press the menu button
2- Scroll to Settings and press OK.
3- Scroll to Display/Info and press OK.
4- From Display/Info, scroll to Clock and press OK.
5- Verify that the Year value is correct.
6- If the Year is not correct, proceed as follow:
a. Scroll to Year and press OK.
b. Use the DELETE soft key to backspace over the incorrect value.
Air-Trak® Handset Set-up Guide
Page 5 of 13