Toshiba RAV-CT100-M Installation And Owner's Manual page 10

DX Air Curtain
Procedure 2
Each time you push
numbers in the control group change cyclically.
Select the indoor unit you want to change settings for.
The fan of the selected unit runs and the louvers start
swinging. You can confirm the indoor unit for which
you want to change settings.
Procedure 3
Using "TEMP",
NO. [ ].
Procedure 4
Using timer "TIME"
DATA [ ].
DX Air Curtain Configuration
The circuit board of the DX AIR CURTAIN is configured at the factory. For reference these are the settings used. Any
changes must be set using the DN code menu.
Follow to the basic operation procedure (1 → 2 → 3 → 4 → 5 → 6).
DN DX AIR CURTAIN MODEL
CODE (RAV-****-M/L)
DIRTY FILTER ALARM
01
(Disabled)
CENTRAL CONTROL ADDRESS
03
(Unset)
AUTO MODE
0d
(Disabled)
10 DEVICE TYPE
11 CAPACITY CODE
POWER ADDRESS
12
(Unset)
DEVICE ADDRESS
13
(Unset)
GROUP ADDRESS
14
(Unset)
AVAILABLE MODE
2d
(Heating & Fan Only)
FAN CONTROL
9b
(Disabled)
* 0099 = address not assigned (system addresses are assigned during the automatic addressing by the system.
Central addresses can be assigned automatically with a central remote control or manually. Subsequent
modifications may lead to malfunction.)
button, indoor unit
buttons, specify CODE
buttons, select SET
CT100BH/CH/UH
0012
0001 (Fan motor operates during defrost cycle)
(To stop fan motor operation during defrost cycle change to 0000)
Procedure 5
Push button. When the display changes from
flashing to lit, the setup is completed.
• To change settings of another indoor unit, repeat
from procedure 2.
• To change other settings of the selected indoor unit,
repeat from procedure 3.
Use button to clear the settings.
To make settings after
repeat from procedure 2.
Procedure 6
When settings have been completed, push
to determine the settings.
When button is pushed,
the display content disappears and the air conditioner
enters the normal stop mode.
(While is flashing, no operation of the remote
controller is accepted).
CT150BH/CH/UH
0000
0099*
0001
0004
0015
0099*
0099*
0099*
0009
10
Installer
button was pushed,
flashes and then
CT200BH/CH/UH CT250BH/CH/UH
0017
button
0018